Dissolve/trans question

Nappy · Post by **Nappy** » Fri Oct 25, 2002 6:47 pm

Ok, so I got this transparency clip, and I wanted to dissolve the 2nd clip into the 1st then dissolve then both to black. I can do the first part, but I'm not sure how to fade both clips to black at the same time. It will only dissolve the 1a clip, any ideas?

FurryCurry · Post by **FurryCurry** » Fri Oct 25, 2002 8:26 pm

I'll assume you're using premiere.

Just use a black still the same size as your video resolution, put it on a higher track than the other two clips, set the duration as necessary, then set the opacity rubberband from 0 or nearly so to climb to 100% at the end of the black clip.

klinky · Post by **klinky** » Fri Oct 25, 2002 9:14 pm

You're using transitions you need to learn how to use the rubber bands.

You'd want something like that.

~klinky

Nappy · Post by **Nappy** » Fri Oct 25, 2002 11:17 pm

tx guys, I thought that rubberband would just change my effect since the name or the effect was in the rubberband area ^_^::