Is this the right place for video help? I'm posting it here.

Corran · Post by **Corran** » Sat Jun 05, 2004 10:37 am

Corran Productions wrote: After they are removed the frame rate is 13.976fps. Premeire however doesn't have a 23.976 timebase to edit in so you have to use assumefps(24)

That should say 23.976fps not 13.976fps.

shirohamada · Post by **shirohamada** » Sat Jun 05, 2004 2:14 pm

decomb5.2.1 filter by Donald A.Graft works charm.
you might wanna check if its a clean 3:2 pulldown or not and use different parameters too see if its helps.
he also got a little guide.

hold on, you're on PAL land.....whatever

Jason 00 · Post by **Jason 00** » Sat Jun 05, 2004 2:23 pm

Yes, after "IVTC" using the Line> assumefps(24) is the way to go.

All I meant was that if you footage is running at 29.97fps adding "assumefps(24)" will cause the footage to play slower (*Big Mess*)

1hr, 33mins and 46secs becomes 1hr, 54mins and 36secs

I probably never should have brought it up.

Nekoboy Sal · Post by **Nekoboy Sal** » Sat Jun 05, 2004 3:59 pm

I get it. I understood it this moring when I woke up. But you just explainded another thing That I would have had to figure out.

Jason 00 wrote:I hope the roofing project is going well (or went well)((whichever applies) )

Yeah the roofing is working out. We had to get some more tiles and now we have to cut them down because they're too big. We almost forgot to put in the skylights before slating the other side

That would have been a problem.
My head has cleared out aswell. I just had one problem trying to get the filter for the nail into the new suport beem, And I am running out slate on my HardwoodDrive. Good thing I have 2 HardwoodDrives