What program could I use to print out a cover for a Dvd Case

leathelanime · Post by **leathelanime** » Fri Aug 15, 2003 3:10 pm

I just bought Silent Hill 2 (AGAIN!) and the case is totally wrecked and I wanted to add a new slide in paper case in it since it's all withered

NME · Post by **NME** » Fri Aug 15, 2003 4:04 pm

Why did you buy a bad looking one?

I HAVE EYES IN YOUR SOUP.

Roke · Post by **Roke** » Fri Aug 15, 2003 4:14 pm

Use some Oxy-Clean. It will fix the cover right up.

LightningCountX · Post by **LightningCountX** » Sat Aug 16, 2003 5:07 pm

Silent Hill was the scariest game ever, until the sequels came out.....=\

Anime Jedi · Post by **Anime Jedi** » Sun Aug 17, 2003 12:03 pm

I can only think of a long and boring way.

You could measure out the lenth and width for the cover, and create your cover accordingly using any program like Photoshop. You should be able to create the pic using inches as the measurement. This was you can divide it up for the back, front and side.

What I used to do when making covers for CDs cases was just to create the cover in Photoshop, then print it in Word (yes, Micrsoft Word). Why in Word? So I could print out more than one on a single sheet of paper, but a DVD case cover would probably already take a full page, so forget about it.

Truest-Chaos · Post by **Truest-Chaos** » Mon Aug 18, 2003 12:25 am

THE PROGRAM WHERE I FUCK YOUR FACE UP FOR DOING ILLEGAL THINGS