Front Case Cover on CaseMaxx 610

User avatar
klinky
Joined: Mon Jul 23, 2001 12:23 am
Location: Cookie College...
Contact:
Org Profile

Post by klinky » Thu May 22, 2003 4:16 pm

Sweet there FurryCurry ;o

User avatar
Akashio
Joined: Sun Nov 25, 2001 6:46 pm
Contact:
Org Profile

Post by Akashio » Sat May 24, 2003 2:11 pm

OK. That works and I feel stupid. However, I put my DVD drive in (facing the right way) and I can't any screw holes to line up with the holes in the bay so I can screw it in place.

User avatar
FurryCurry
Joined: Sun Jul 14, 2002 8:41 pm
Org Profile

Post by FurryCurry » Sun May 25, 2003 1:43 pm

Your case probably came with drive rails, either in a plastic baggie of parts, or in brackets attached to the bottom of the inside of the case, like these:

Image


Slide a couple of those out, (don't try to pry or snap them up, slide towards front or back) and attach them with a couple screws per side, so the metal tabs are very close to the front bezel of the drive:

Image


Slide the drive into a bay (from which you have removed any metal shield plate blocking it)

Image


and push it firmly in until the metal tabs snap into their locked position.

Image


To remove the drive again, squeeze in firmly on both of those metal tabs, and pull forward.
My Eyes Are The Victim's Eyes.
My Hands Are The Assailant's Hands.

User avatar
klinky
Joined: Mon Jul 23, 2001 12:23 am
Location: Cookie College...
Contact:
Org Profile

Post by klinky » Sun May 25, 2003 6:59 pm

Nice pictures ;o

Locked

Return to “Hardware Discussion”