Front Case Cover on CaseMaxx 610
- klinky
- Joined: Mon Jul 23, 2001 12:23 am
- Location: Cookie College...
- Contact:
- FurryCurry
- Joined: Sun Jul 14, 2002 8:41 pm
Your case probably came with drive rails, either in a plastic baggie of parts, or in brackets attached to the bottom of the inside of the case, like these:
Slide a couple of those out, (don't try to pry or snap them up, slide towards front or back) and attach them with a couple screws per side, so the metal tabs are very close to the front bezel of the drive:
Slide the drive into a bay (from which you have removed any metal shield plate blocking it)
and push it firmly in until the metal tabs snap into their locked position.
To remove the drive again, squeeze in firmly on both of those metal tabs, and pull forward.
Slide a couple of those out, (don't try to pry or snap them up, slide towards front or back) and attach them with a couple screws per side, so the metal tabs are very close to the front bezel of the drive:
Slide the drive into a bay (from which you have removed any metal shield plate blocking it)
and push it firmly in until the metal tabs snap into their locked position.
To remove the drive again, squeeze in firmly on both of those metal tabs, and pull forward.
My Eyes Are The Victim's Eyes.
My Hands Are The Assailant's Hands.
My Hands Are The Assailant's Hands.
- klinky
- Joined: Mon Jul 23, 2001 12:23 am
- Location: Cookie College...
- Contact: