Masking: Stepping through a top layered mask

For all help and discussion relating to visual effects in programs that are not already covered in an existing forum, such as Blender, Particle Illusion, etc., along with discussion about effects theories and techniques.

Moderator: Niotex

User avatar
Joined: Tue May 08, 2007 11:16 pm
Org Profile

Masking: Stepping through a top layered mask

Postby JazzyDJ » Tue Mar 24, 2009 9:05 pm

I have an idea where I'd like to have the screen (the masks top layer) be either ripped or breaked by a beast from behind that layer who makes a whole in the middle of the screen, and then steps over and walks through that whole to become the main main figure/front layer. Any one have some good ideas or knowlege of how to do this?
Number 1 on the Bottom 40

User avatar
Crazy Cat Lady!
Joined: Tue Mar 16, 2004 6:25 am
Status: I has a TRU Arceus
Location: somewhere i think O.o
Org Profile

Re: Masking: Stepping through a top layered mask

Postby JaddziaDax » Fri Mar 27, 2009 6:55 am

use several layers... for the main beast put it in the back (or on the bottom layer), do the shatter on the middle and the parts of the beast that go in front of the shattered part put them on the top layer.... its going to take a long time to do but if you pull it off it might look cool

Return to “Visual Effects”

Who is online

Users browsing this forum: No registered users and 1 guest