Hello all,
This is my first time posting here, so please excuse any blunders!
I have an issue with edge artifacts/noise being caused by transitions when exporting an .avi. (And viewing the exported clip in Virtualdub or similiar programs.) If I disable the transition, then the noise disappears in the exported .avi. I have tried to use an additive dissolve, cross dissolve, as well as simply adjusting the clip opacity to duplicate a dissolve, but every method I have tried has produced the edge noise/artifacts.
The settings for the project are as follows:
Editing mode: Desktop (standard settings)
Video Rendering:
File format: Video for Windows
Compressor: Huffyyuv v2.1. ("YUV Renderer Fix")
I usually further export the movie as a "Huffyyuv v2.1" movie. (Using the "YUV Renderer Fix" compressor, which I believe is the same as the "Huffyyuv v2.1" Also, I have the project settings set for RGB (RGB compression method: Predict Gradient (Best)), as well as exporting as RGB as opposed to YUV. (Since exported YUV clips tend to crash my VirtualDub, which is an annoyance...)
Incidentally, I had tried everything I could attempt/research to track down the cause of the issue, and I finally disable the transitions, which caused the issue to disappear. So I am pretty sure this issue is related to the transitions. (It took me a week to figure this out, which is a bit fustrating!)
Any help would be much appreciated, and I can provide futher assistance if required.
Thanks in advance!
Baculus
