The performance at lower ratios, on the other hand, took our memory to performance levels never reached on any board - AMD or Intel. Both the Geil and OCZ memories are based on very recent Samsung TCCD memory chips, which performed well in our recent memory tests on an Intel test bed. They topped out at DDR557 to 561 on the Intel, so I was skeptical when DFI told me that TCCD memory could reach DDR600 on the nF3-250Gb. With a little tweaking, we were able to reach even further with this same memory, to DDR616 at 3-3-4-10 memory timings at 2.8V memory voltage.
Miz Ducky wrote:You entirely lost me when you started mentioning dividers, multipliers and ratios
Miz Ducky wrote:Since you just went through a major upgrade to the Athalon 64, why do you still have a 200 MHz motherboard?
madmag9999 wrote:yea Z3r01 you lost me a little bit with the divider thing. maybe i know what it is just not useing that term becouse i have been ocing systems for a long time.
Z3r01 wrote:I had an XP2600 a while ago, (runs default at 2075MHz (12.5 x 166)
Phade wrote:(I've actually promised to spend some time with my wife now. It's "happy Friday time".)
Zero Serenity wrote:Z3r01 wrote:I had an XP2600 a while ago, (runs default at 2075MHz (12.5 x 166)
I don't mean to be picky, but how do you run half a processor at default?
-Zero
Phade wrote:(I've actually promised to spend some time with my wife now. It's "happy Friday time".)
Zero Serenity wrote:1. Factory Default is hugely underclocked, as in each segment processor was set to half it's capability. (In this case, it was set to 166MHz, but capable of 333MHz)
Z3r01 wrote:So where does the 333FSB come into it? It's probably just the manufacturers reffering to its theoretical throughput, ie as in both channels being used at once. (I'm assuming the FSB works on a full duplex basis, and is 166MHz each way)
Zero Serenity wrote:Oh. Heh. I see. To me it sounds AMD was falsely labeling or advertising their processors. Am I still off?
-Zero
Return to Video Hardware Discussion
Users browsing this forum: No registered users and 1 guest