Front Case Cover on CaseMaxx 610

This forum is for help with and discussion about your video hardware.

Postby klinky » Thu May 22, 2003 4:16 pm

Sweet there FurryCurry ;o
User avatar
klinky
 
Joined: 23 Jul 2001
Location: Cookie College...

Postby Akashio » Sat May 24, 2003 2:11 pm

OK. That works and I feel stupid. However, I put my DVD drive in (facing the right way) and I can't any screw holes to line up with the holes in the bay so I can screw it in place.
User avatar
Akashio
 
Joined: 25 Nov 2001

Postby FurryCurry » Sun May 25, 2003 1:43 pm

Your case probably came with drive rails, either in a plastic baggie of parts, or in brackets attached to the bottom of the inside of the case, like these:

Image


Slide a couple of those out, (don't try to pry or snap them up, slide towards front or back) and attach them with a couple screws per side, so the metal tabs are very close to the front bezel of the drive:

Image


Slide the drive into a bay (from which you have removed any metal shield plate blocking it)

Image


and push it firmly in until the metal tabs snap into their locked position.

Image


To remove the drive again, squeeze in firmly on both of those metal tabs, and pull forward.
My Eyes Are The Victim's Eyes.
My Hands Are The Assailant's Hands.
User avatar
FurryCurry
 
Joined: 14 Jul 2002

Postby klinky » Sun May 25, 2003 6:59 pm

Nice pictures ;o
User avatar
klinky
 
Joined: 23 Jul 2001
Location: Cookie College...

Previous

Return to Video Hardware Discussion

Who is online

Users browsing this forum: No registered users and 1 guest